Don't know if this helps at all but you can hear the tension when it goes wrong !
This chart applies to LHR 27L approach plate. Standard missed approach/go around procedures seems to my untrained eye to be to follow the instructions to climb to 2000 feet on runway heading and at 1080 feet or I-LL DME, whichever is later, turn left to 149 degrees. Continue climb to 3000 feet to LON DME 6 and then follow ATC instructions. Otherwise, proceed to Epsom NDB and fly holding pattern at 3000 feet and await instructions.
I think I've read that correctly ?
What I cannot find anywhere is any written instructions to be applied to any other potential conflicting aircraft. I can only assume that other potential conflicts will be instructed appropriately by ATC to maintain separation.
As far as GA VFR airfields are concerned any aircraft going around will turn to the dead side of the circuit after stating intentions on the area or field frequency and engage Mark One eyeball radar scanning while maintaining VFR and rejoining the circuit according to published joining instructions.
Do I pass this section of the test ?
This chart applies to LHR 27L approach plate. Standard missed approach/go around procedures seems to my untrained eye to be to follow the instructions to climb to 2000 feet on runway heading and at 1080 feet or I-LL DME, whichever is later, turn left to 149 degrees. Continue climb to 3000 feet to LON DME 6 and then follow ATC instructions. Otherwise, proceed to Epsom NDB and fly holding pattern at 3000 feet and await instructions.
I think I've read that correctly ?
What I cannot find anywhere is any written instructions to be applied to any other potential conflicting aircraft. I can only assume that other potential conflicts will be instructed appropriately by ATC to maintain separation.
As far as GA VFR airfields are concerned any aircraft going around will turn to the dead side of the circuit after stating intentions on the area or field frequency and engage Mark One eyeball radar scanning while maintaining VFR and rejoining the circuit according to published joining instructions.
Do I pass this section of the test ?
Comment