I noticed on most of my pictures that I attempted to upload to Jetphotos are all mostly rejected for being soft. I don't know whether this photo should be appealed or should be edited once more. Any feedback on this picture? Especially where the soft spots are.
Announcement
Collapse
No announcement yet.
Rejected for soft
Collapse
X
-
The photo is definitely soft, partly also due to the JPG compression. Best visible on the windows and other edges.
-
Originally posted by AeroBlue View PostI noticed on most of my pictures that I attempted to upload to Jetphotos are all mostly rejected for being soft. I don't know whether this photo should be appealed or should be edited once more. Any feedback on this picture? Especially where the soft spots are.
http://www.jetphotos.net/viewreject_b.php?id=5206844
Comment
-
Originally posted by dlowwa View PostAs Gerardo said, whole aircraft is soft, though if the original image is sharp, a better edit may make it acceptable. Hard to say without seeing the original.
Comment
-
Originally posted by AeroBlue View PostI think found the problem. It turns out I was sharpening the image before resizing the image to 1200x900, which rendered the sharpness applied before basically useless. A simple mistake that I could've known earlier. Also, any tips for sharpening an image?
From my experience screeners are much more likely to give an undersharpened rejection than an oversharpen. I can't recall the last time I had an oversharpen rejection! BUT be very careful of oversharpening, because once you oversharpen the photo, it cannot be recovered and you might have to start over again.
Good luck!
Comment
-
That is not because of the screeners, but because of the normal editing process. If you re-size a pic most re-sampling methods create bit of softness, which needs to be corrected with a bit of sharpening even when the 100% original was pin sharp. Many people seem to not know this. To create an over-sharp picture you usually must add too much sharpening, so we see way less of those than of the soft pics.
Comment
-
Originally posted by AeroBlue View PostI think found the problem. It turns out I was sharpening the image before resizing the image to 1200x900, which rendered the sharpness applied before basically useless. A simple mistake that I could've known earlier. Also, any tips for sharpening an image?
1. Level the original.
2. Crop to size.
3. Check for and remove any dustspots.
4. Adjust both ends of the luminosity histogram.
5. Create a background layer and sharpen using USM set to 50-0.2-0. Stop and go back one step if you see jaggies appear.
6. Delete the sky area and flatten the image. This will remove any sharpening artefacts from the sky.
7. Save at maximum resolution.
This is my basic workflow. If you choose your best original image you should not have to fiddle around any more.
The most important thing is to make sure that the original is properly exposed. If you start with a good shot then you won't have to do much processing.
Oh yes, one more thing. If you are a Nikon user make sure that "D Lighting" is disabled in your camera. That is the main cause of haloes.Last edited by brianw999; 2016-03-23, 11:01.If it 'ain't broken........ Don't try to mend it !
Comment
Comment